Furnace Cold Air Return Duct

If you had no return air in your room you would create a positive pressure.

Furnace cold air return duct.

Supply air from furnaces and air conditioners should be on outside walls. Place your cold air return vents on the inside walls of buildings at the lowest point. Menards offers a wide range of ductwork pipe and fittings to help your ductwork systems run efficiently these products are used for warm air return supply and exhaust systems. If the supply ducts are in the floor then the return air should be located up high.

Used as a central return vent box filter grill not included. It is important to understand the space that you re heating. A furnace return system must collect all the air being put out by that system. Product is knocked down for shipping and must be assembled.

The duct board return air box is an r6 the duct board return air box is an r6 insulated box that installs traditionally in a ceiling. An insufficient return system or one too large will reduce the efficiency of the heating and increase energy bills. The return vent pulls. For the system to work you have to re circulate the air back to the furnace.

In addition its flexibility allows for easier installation in hard to reach areas. The return air vent openings need to be on the opposite side of the room so the conditioned air is pulled across the room. Can be easily cut to size. That would then reduce the flow of conditioned air to that space.

The location of cold air return vents step 1. Can accept any size collar up to 18 in. Flexible duct can be installed in place of galvanized pipe in many applications if allowed by your local hvac codes. This pulls the air across your body.

The output of air.