You could damage the clutch the clutch fork or the transmission.
Flutch stuck to floor no leaks.
Could it be something with the clutch pressureplate flywheel.
I work by myself.
Diagnosing a clutch pedal on the floor due to failed release bearing.
If there are no fluid leaks at the master cylinder no swirl or bubbles in the clutch reservoir and the clutch pedal does not slowly descend with constant pressure then the master cylinder is likely working.
Do not attempt to start the engine and drive the vehicle with the clutch pedal stuck all the way to the floor.
No leaking or anything.
It started drove awhile then repeated the problem.
No fluid leaks visible at slave cyl or lines.
Floor or engine bay leaks.
All of a sudden clutch pedal fell to floor no pressure.
Preparing the vehicle to check the clutch pedal for a failed release bearing.
Part 1 of 4.
Trying to narrow it down before i have to pull the trans out.
Common reasons for this to happen.
I was told to put a tube i used 1 4 line.
You could damage the clutch the clutch fork or the transmission.
My 1991 rx7 s clutch went so loose that it actually stuck to the floor and the car died.
And pump the hell out of the clutch.
Verify all lines between are not leaking.
Do not attempt to start the engine and drive the vehicle with the clutch pedal stuck all the way to the floor.
There s only two ways the pedal can go to the floor.
As mentioned earlier leaky cylinders can t maintain the requisite pressure to function properly and should be replaced.
Replacing the cable will allow you to engage the clutch and change gears once more.
I hand pumped my clutch for about three hours straight.
So i was trying to two man method to bleed it myself.
Just because the mechanic saw no leak doesn t mean it s not leaking now.
Everything seems intact still.
To my bleeder valve on slave cylinder and put the other end in my master cylinder reservoir.
Seems like it has no compression fixing the clutch i bet one of the lines had been leaking clutch fluid for quite a while.
If your car s clutch slave cylinder is failing you can also expect to see some visible leaks.
Mechanical failure linkage pedal breaks pressure plate breaks clutch fork breaks or becomes detached or hydraulic failure the hose ruptures one of the cylinders fail or the fluid level drops below the pickup level.
Ok so everything has been fine.
Replaced master cylinder 2 months ago and slave cylinder is new too a yr ago.
Check underneath your vehicle for any pools of liquid and check the engine bay too.
Obviously my clutch is bleeding down.
Still no pressure in clutch.
At home i pulled the clutch pedal back up by hand started it up in neutral pushed the clutch pedal in put it in reverse it went in and immediately the clutch started to engauge pushed clutch in and it stuck to floor again.
Now it won t start.
